40,376 views
📌Order link Power supply board (in the clip) LAZADA 👉https://s.lazada.co.th/l.bYxe SHOPEE 👉https://shope.ee/8KEDZ4UePa Hello, welcome everyone to the ZimZimDIY channel. Today I will review the power supply board or the power supply board. The new product is very interesting. It is used with the computer's power supply. I thought it was cool, so I bought it and tried it. When I used it, it was okay. It is convenient and the price is not expensive. One is about 50-60 baht. The advantage is that we do not have to cut the power supply jack cable. Just plug the 24-Pin jack into its socket. There is an on/off switch on the top left and a red status light on the right. When the power is on, it is designed with a fuse to prevent short circuits at every point before the output power, but it is a 20A fuse. For the Ouput terminal that will be connected to use, it is written to specify the voltage at each point clearly. The ground terminal will be black, the positive terminal will be red, and there will be a voltage of 3.3V and Gnd, 5V and Gnd, 12V and Gnd, and -12V and Gnd. The bottom of the board, the copper pattern is quite thick. If friends want the power to flow more conveniently, it is recommended to remove the terminal and solder the wires. It should be better. Here, I have an old computer that is no longer in use. I removed the screws. After that, I only removed the Powersupply. The various wires will be stuck. So, squeeze and release them, squeeze and release them all. We will only be interested in the 24-pin terminal. Push it to lock it, plug it in, and turn on the switch. That's it. The board is ready to supply power for us to use. If you look at the fan, it is spinning. The power is waiting. Check the voltage to see if it is real. 3.3V 5.2V 12V -11.4 V 3.3V can be used with LED bulbs. 5V can be used to charge mobile phones. The ground can be connected to any port. The same ground and 12V can be used as a power supply for a mini amp board. Because most power supplies can supply more than 10A. Or if that's not enough, you can use a step-up module to connect in parallel. And the most important advantage of the power supply is that it has an automatic power cut-off system in case the load is shorted. I'll try using a wire to touch between the +12V and Gnd terminals. Here it is. You will hear a flash for a moment and then the device will cut off the power. We just turn off the switch and turn it back on again. The device will work normally. This is a multi-purpose power board that is worth buying and finding to use. It will make our DIY work much easier. For friends who are interested I will leave the link below this clip for you. Thank you to all my friends who have watched it.