21,520 views
*****MATERIALS ***** FOR THE HAT CROWN -1 25 cm latex balloon -Black acrylic paint and brush -3 strips of 3 by 60 cm cardboard to measure the head -stapler -Cut newspaper into pieces -White glue diluted in water or paste -54 cm cardboard circle for the brim of the hat. -Black felt for crafts. -For petals, use a 13.5 by 11 cm cardboard mold. For the Skull mold, use Cardboard. Point from the center of the 16 cm head, mark tabs at 3 cm and cut. -I used a frying pan lid for the circumference of the cup and used masking tape or body tape. Make cuts 3 cm apart for the brim of the hat and 4.5 cm and 4 on the sides (follow the steps in the video) -Cut a piece of felt measuring 54.5 cm, the other piece is 58 cm (the largest one goes on top) -Small skull measuring 4 by 4 cm -Large petal skull measuring 7 by 6.5 cm -Skull in the center of the hat strip measuring 5.5 by 5.5 cm -the center strip is 6 by 32 cm -Strip of silver, black, white and black sequins. For small skulls, white glitter that I glued with cold silicone. -7 by 8.5 cm triangle to make a rhombus -2mm thick silver thread and 2 meters 10 centimeters long. -Large needle (capotera) -Wooden stick and awl. -For decorative ribbon, use one that is 4 cm wide or braid for the edge of the hat if you wish. - Skull for center 5.5 by 5.5cm - Felt strip for inside hat is 2.5 wide due to head circumference. - 2 strips of silver ribbon to tie with a bead ball. Craft cord for side decorations in silver color 1 cm thick, cut 24.5 cm and roll and glue on white or black felt. - Small cord 9 cm and fold and 2.5 cm strip to roll tips. - Silicone gun - cutter, scissors