37,647 views
Connecting the wires is the same as the 2016 Anova. This method is identical to the same work of the agency. There is another method that they use. Connect only one wire to the computer and connect the second to the negative of the car’s iron. I do not recommend this method. My experience with the stabilizer using this method was for a period of 4 months without problems. The same explanation as the clip. When there is a malfunction in the car, the stabilizer does not work. An alarm bell sounds and words appear on the screen in English. I do not know what it is. You know, half-full is not Arabized. The information screen if the check light is on or if you disconnect the ABS, if you disconnect the disconnection and leave it disconnected, it will be fixed for a limited and very short period, then the stabilizer will disconnect automatically. There is a case where if the check light is not on, the computer begins to lose part of the programming. The car needs to be turned off and turned on again so that the stabilizer does not confuse. For example, if the speed is fixed and you need to supply it with the stabilizer, it will continue to supply it as it pleases. If you are stuck and the clutch is open, make sure that the clutch on the agency system is 190. This applies to those who have a clutch. You can keep the speed to the last 208 km if the speedometer stops below 200, provided that you continue to step on the clutch. You know the problems with the new model with the clutch.