1,841 views
This video discusses errors that occur when working with the ElPower script. You can also read the document, which contains a full description of possible errors: https://injectorservice.com.ua/docs/u... Video content: Errors that occur when working with the ElPower script: Voltage channel is specified incorrectly; Battery voltage not detected; Current channel is specified incorrectly; Starter current not detected; Charging current not detected; Current is too high. Check the range of the current clamps; Reverse polarity of the current clamp connection; It is recommended to charge the battery; The battery needs to be charged; The battery is worn out - it is recommended to replace it; Your version of the ElPower script is out of date; A new version of the ElPower script is available; Install the USB Oscilloscope program update; The section suitable for measuring compression was not found; The section for measuring compression is too short; The compression measurement results are unstable. Try to repeat the test or measure compression using other methods; The number of engine cylinders is specified incorrectly; Inappropriate conditions for measuring compression; There is no connection to the server https://waveform-analyzer.com/. Please check your Internet connection. Signal analysis will be performed offline, the results obtained may be incomplete or inaccurate!; An unexpected error occurred; try again later.