281,615 views
Buy a set of bearings for a washing machine https://tehremont.xyz/g60088776-podsh... Buy spare parts for washing machines https://tehremont.xyz/g60181826-zapch... My spare parts store https://tehremont.xyz Everything about repairing washing machines, refrigerators and vacuum cleaners https://sammaster.xyz I offer you a video in which I told you why the bearings on a Samsung washing machine broke down literally 2 months after the master changed them. In this video, you will learn about the mistakes that novice craftsmen and people who are faced with replacing bearings on a washing machine with their own hands for the first time often make. I draw your attention to the fact that it does not matter that this video is about a Samsung washing machine, this video is universal and will suit almost all brands. On my channel, the opinion is often heard that such repairs are inappropriate and the machine after this can work normally for no more than a year. Personally, I fundamentally disagree with this, if everything is done correctly, then the bearings will last for many years. In my practice, I have come across washing machines whose bearings I replaced 10 years ago. Everything depends on the approach to repair, the main thing here is to choose high-quality spare parts, install everything correctly, remove play on the drum and shaft, and most importantly - choose the right seal and install it so that it does not leak water. Lubricant for the seal must be special - in no case use graphite grease, lithol, solidol or any other ointments that are not intended for lubricating the seal in the washing machine. Once, I also used lithol and I must say the machines worked well, but time goes by and over time, powders, spin speed and other factors that affect the wear of the seal change. In general, you need to use only what is intended for this procedure, do not invent and cheapen the repair, believe me, it will come out sideways later. I would like to say separately about the water leak from under the sealing rubber. It is imperative that when you connect two half-tanks, you need to coat the rubber with sealant. Here you need to take into account that over several years of operation, the seal has acquired its shape and when you reconnect the half-tanks, it is almost impossible to put them back in their original place, as a result, if you do not coat the rubber with sealant, water may leak from under the tank. In this video, I clearly showed how and most importantly on which part the water leaked. If you want the control module and motor to remain intact, then first of all, you need to make sure that there are no leaks. I almost forgot, it is imperative to clean the tank and drum from scale and dirt, since during installation, this dirt can get on the seal, as a result, it can fail. Enjoy watching, subscribe to the channel