808,994 views
DONATE: Everyone Who Wants to Help Develop the Channel So that the Videos Come Out More Often and Become Better Quality, You Can Donate Absolutely Any Amount. DONATE: 4149499389375906 Bogdan (Privat Bank) Having chosen the installation method, think about how to connect the equipment. You can do this by following simple instructions: Install the rear view camera in the niche above the bumper. To do this, you need to drill two holes for mounting the bracket and one for the cable. Prepare the wires that you use to connect the device. If they are too short, extend them. Then connect the power wire coming from the video cable to the wire that will be powered by the reversing lamp. As for the second wire, which will be attached to the car body, give its end the shape of a ring. Run the wires inside the trunk, connect one of them to the side lights of the car, and pull the second into the cabin. Carefully insulate the connection points. To make it easier for you to work, first remove the headlight and disconnect the terminal. Install the headlight in place, achieving a completely tight connection. And then lay the wiring along the right side of the car. To connect the camera, you do not have to remove the front passenger seat - just fold it back and remove the seal. Run the cable under the mat of the front passenger seat and bring it into the space of the central panel. Remove the radio and connect the cable to the CAMERA IN output. It does not matter what kind of radio you use - in any case, the equipment will work stably. Go to the "Back camera" section in the radio settings and activate the "Battery" function. As a result, the rear view camera will be powered by positive potential. After performing all of the listed operations, the camera will turn on simultaneously with the reversing lights. And the picture from it will be transmitted to the radio screen.