53,905 views
Replacement, adjustment, installation of the carburetor on the Lifan 177 hp engine for a motorized towing vehicle. Making a homemade filter with heating. Adjusting the fuel pump. Supplement after operation!!!!!!! Here a problem with the needle hanging appeared. It turns out that the float stroke to the stop at the bottom of the float chamber is small and the gap in the retaining bracket is large and cannot pull out the needle. In short, I bent everything on the float. I aligned the tongue flush with the plate and adjusted the level by bending the axis of rotation of the float. Now the float is parallel to the connector. I keep the level 2-3 mm below the connector. If you make 7 -9 it becomes lean under load. The overflow tube is already higher. Check only with a specific pump on the move through the drain hole. Follow the links and subscribe to the channel: Zen: https://zen.yandex.ru/id/623bc538371d... RUTUBE: https://rutube.ru/channel/26159018/