405,667 views
In this video I show you how to reset or reset the Computer (ECU) of a Nissan Tiida WITHOUT A SCANNER so that all the fault codes that are stored in the ECU memory are erased. THIS PROCEDURE WORKS FOR ALL NISSAN CARS. It is very important to perform this procedure that I am going to show you to avoid further failures when you change any sensor, program the throttle body manually or change the horn track; watch this tutorial until the end and you will be able to do it yourself easily and quickly, in addition your Tiida will already work correctly and you will save a lot of money. ***********RESET NISSAN ECU*********** TO ERASE ALL FAULT CODES NOTE: USE A STOPWATCH 1.- HEAT UP THE ENGINE TO THE CORRECT OPERATING TEMPERATURE (THE CORRECT TEMPERATURE IS WHEN THE RADIATOR FAN IS ACTIVATED) 2.- TURN OFF THE ENGINE AND IMMEDIATELY TURN THE SWITCH AND COUNT 3 SECONDS 3.- THEN START AND RELEASE THE ACCELERATOR PEDAL 5 TIMES IN 5 SECONDS AND LEAVE IT WITHOUT PRESSING IT 4.- THEN COUNT 7 SECONDS 5.- THEN START PRESS THE ACCELERATOR PEDAL AND COUNT 10 SECONDS 6.- THE LIGHT WILL START TO FLASH CHECK WARNING LIGHT 7.- WHILE FLASHING, RELEASE THE ACCELERATOR PEDAL AND IMMEDIATELY PRESS IT AGAIN. 8.- THE CHECK WARNING LIGHT WILL START FLASHING FASTER. 9.- WHILE FLASHING FASTER, RELEASE THE ACCELERATOR PEDAL AND CLOSE THE SWITCH AND IMMEDIATELY START THE ENGINE AND THE CHECK ENGINE WARNING LIGHT WILL GO OFF AND ALSO ALL FAULT CODES THAT WERE STORED IN THE COMPUTER MEMORY WILL BE ERASED AND YOUR TIIDA OR ANY NISSAN CAR WILL NOW WORK CORRECTLY.