16,997 views
How to read a foundation project? The isolated footing is a type of shallow foundation. The project for this type of foundation has some particularities, such as the collar. Learn how to read and interpret a complete project step by step. ✅ Learn Eberick TODAY - http://bit.ly/CursoEberick21 📌 MINICOURSE TRACE THE TRACING - Learn how to calculate the concrete stroke at a time with a step-by-step guide http://estruturasebim.com/comece-por-... 👉 Visit our website and secure your materials https://estruturasebim.com ⭕ EQUIPMENT AND BOOK: 💻Notebook that I use to design WITHOUT LOCKING: https://amzn.to/3zuIkEH ⌨️ Calculator model that I use to calculate: https://amzn.to/3oqi0oP 👉 📚Book Calculation and Detailing of Usual Reinforced Concrete Structures: https://amzn.to/3jfyFbX 👉How I learned Revit from basic to advanced https://bit.ly/RevitdoBasicoaoAvancad... Hello, how are you? The isolated footing is a shallow or direct foundation, and its use is very common in Brazil, because it is capable of receiving specific or concentrated overloads. In addition, the isolated footing is a type used in medium or large house projects, because it exclusively receives the load of a pillar. The foundation project must contemplate the positioning of the footings, respecting the axes. Don't forget to include the identification with the name of the footing, scale and dimensions. The pre-dimensioning of the footing can be done through the proportion, where the height must be at least 30% of the largest side. Another point, the issue is that the footing does not always need to have a pyramid. The reason for adopting the pyramid is because of the bending moment, which increases from the end of the footing to the face of the pillar. The shape of the footing depends on the geometry of the pillar. For example, if you have a square pillar, this indicates the shape of the footing to adopt. One fact about the foundation inclination is that 1:3 can be used. In episode 5, we discussed reinforcement, steel support, gravel ballast, stirrups and others. In this way, each detail has a nomenclature that includes the number of bars, position in the project, bar diameter, length and bends. I hope you learn and will be available to watch countless times. Good studies! BIG hug! Eng° Pedro Rodrigues