959 views
jaguar x type I tried to explain how to check the crankshaft position sensor (CKP sensor) test is very simple and easy. You can also test the crankshaft position sensor (CKP sensor) in this way. error codes are P0335, P0336. meanings Crankshaft position (CKP) sensor problem. CKP sensor. CKP sensor circuits. CKP sensor air gap. CKP sensor debris Crankshaft Position (CKP) Sensor The crankshaft position (CKP) sensor is mounted in the cylinder block at the rear of the engine. It is used to detect the engine position and speed of the crankshaft. It is a permanent inductive type sensor. If the CKP sensor fails, the engine will NOT run The crankshaft position (CKP) sensor signal is the basis of ignition timing calculations. The alternating voltage signal from the CKP sensor is converted by the engine control module (ECM). This digital signal is then used to locate the closing time of the primary circuit of the ignition coil. The effective range of the ignition timing control is increased by having no rotating parts Error codes P0335, P0336 Problem with the crankshaft position (CKP) sensor. CKP sensor. CKP sensor circuits. CKP sensor air gap. CKP sensor debris. Go to Pinpoint TestB. Electronic Engine Controls - 2.0L NA V6 - AJV6/2.5L NA V6 - AJV6/3.0L NA V6 - AJ27 - Crankshaft Position Sensor (CKP) Removal and Installation Removal 1. Remove the right front road wheel. Refer to Section 204-04 Wheels and Tires for additional information. 2. Remove the wheel arch liner access cover. 3. Disconnect the CKP sensor electrical connector. 4. Remove the CKP sensor. Remove and discard the O-ring seal. Installation 1. NOTE: Install a new O-ring seal. To install, reverse the removal procedure. Tighten to 10 Nm.