https://www.ersatzteilshop.de/?t=yt In this tutorial we will deal with the topic of connecting the washing machine. You can find the right washing machine here: https://www.allego.de/waschmaschinen/ Basically, connecting the washing machine is not a problem. However, there are a few small things that you should pay attention to when connecting the washing machine. First of all, you need a few tools, which should be available in almost every household. For example, a water pipe wrench, a spirit level, a screwdriver and a knife;) to unpack the washing machine. Once you have these tools together, unpack the washing machine and look for the bag with the instructions, the installation description and the installation accessories. Once you have done that, look at the back of your washing machine. In order to be able to connect the washing machine, you first have to remove the transport locks. These are usually 3 - 4 larger screws on the back of the washing machine. You unscrew all of these screws anti-clockwise. When removing the screws, it is important that the guides for the screws must also be removed. You should keep these brackets and screws in case you move the washing machine later and possibly reinstall them at some point. Once the transport locks have been removed, the blind plugs follow. These are only used to close the housing so that no dust can get into the inside of the washing machine and are included with the washing machine. Once we have completed these steps, we will look at the water inlet hose. If this is already firmly attached, then we don't need to do anything else for now. If the hose is not yet attached, as in the video, then we put it on the water inlet valve and screw it tight. Here you will need the pliers to really get the connection tight. Once all of that is done, it's time to align or level the washing machine. This tutorial will help you with that: • Leveling the washing machine, washing machine... In order to be able to connect the washing machine, the water inlet and water drain must now be installed. When it comes to the water drain, you should check again to see if a blind plug is installed. This would then of course have to be removed so that the washing machine can also pump out at the end. You should now connect the drain hose to the house connection using a hose clamp. Once you have pushed the drain hose on, secure it with the hose clamp. Next comes the water inlet hose. Most washing machines have an Aqua Stop valve on the side of the tap. This is a water protection system that is intended to prevent flooding if the inlet hose bursts. When attaching the thread to the tap, it is important not to tilt it. If in doubt, this would destroy the thread and you would not be able to connect the washing machine any further. When screwing it tight, please turn the inspection eye of the Aqua Stop valve forwards so that you can still see and check it. Now use the pipe wrench to tighten the connection. In the last step, plug in the plug and start a control program. When the program runs through, check whether all the hose connections are really tight. I hope this tutorial has helped you connect your washing machine... So, let's get to work!