19,605 views
The process of removing standard and installing offroad tires for the Ninebot mini gyro scooter is shown. The method is suitable for any tires of this size. 1. The standard rubber is soft enough and can be removed from the disk by hand. But if this is difficult in your case, it is convenient to use a clamp for this. 2. In order not to damage the edge of the tire when removing it from the disk, it is necessary to sink one side of the rubber as deep as possible inside the disk and remove it from the back side, a plastic tie will effectively help with this. 3. Difficulties often arise when trying to inflate a wheel when the tire has not yet sat on the disk. To make this task easier, roll the tire with the disk under your weight. This will make the rubber expand and almost sit it on the disk, then with the compressor turned on, it will be enough to slightly press in the place where the air comes out and the tire will quickly and easily inflate. It is necessary to inflate the tire with slightly more pressure so that it sits well on the disk, with characteristic clicks when landing. You can watch other videos from the offroad tires series in the following videos: Making fenders for higher offroad tires: • Making offroad fenders for Nine... Upgrading original fenders for offroad tires: • Modifying standard Ninebot min fenders... Test drive of offroad tires on different surfaces in dry weather conditions: • Offroad Xiaomi Ninebot mini 2WD++ by ... appearance with offroad tires: • Appearance of the modified Xiaomi Nine...