17,994 views
An improved Puch Maxi housing! The Addy 50 clears up all the old problems of the Puch E50 housing and offers some additional improvements. Today we're looking at workmanship, features and quality. The Addy 50 is not just a replica but a full-fledged 2.0 version. It offers numerous revisions and improvements compared to the original E50: • Widened sealing surfaces • Threaded oil drain plug • Block reinforced at critical points • Large cylinder base • GME – preparation • 4 – bearing block • Layout screws in the housing • Screw points ignition • Oil baffles for lubricating film • Radiator fins for gearbox and crankcase • Reinforcement through centering pins This is what I have to complain about: • No kickstarter possible • No main stand possible • Water drainage missing • ÜS a bit too wide from the factory • Screw set • Pinion max. 17 teeth Things that could cause confusion: • The centering pins are not absolutely necessary • No membrane block has to be installed • The milling edge is not a problem even with 0.3 mm seals • 8.8 screws can be used, 10.9 are optional • Target play gear wheel at least 0.15 mm You can find the Addy 50 here: https://www.puchshop.de/de-DE/pre-ord... Engine stand Puch Maxi engines: https://puch-ersatzteile.at/allgemein... Here you can find the Stage6 reed valve box: https://www.ebay.de/itm/284342538323?... Thanks for watching! Here you can find my Instagram channel: / puchpraxis Content: 00:00 - 00:06 Intro 00:06 – 00:24 Introduction Addy 50 00:24 – 00:50 Scope of delivery 00:50 – 01:13 our “B” model 01:13 – 03:12 Improvement compared to E50 03:12 – 07:11 Improvement for tuning 07:11 – 08:00 Membrane block and dimensions 08:00 – 08:31 Screw layout and dimensions 08:31 – 09:05 Changes in casting and weight 09:05 – 10:02 Splitting the engine 10:02 – 10:24 Centering pins 10:24 – 10:36 Ventilation gearbox M6 10:36 – 11:10 Reinforced points in Block 11:10 – 11:41 Casting quality 11:41 – 12:40 Reed valve block 12:40 – 13:11 Reed valve boxes 13:11 – 13:30 Matching cylinders 13:30 – 14:28 Casting quality 14:28 – 15:28 Milled surfaces 15:28 – 15:55 Screw set 15:55 – 20:05 Not so exciting 20:05 – 22:31 Calibrating the gearbox 22:31 – 23:56 My opinion / Outro