24,620 views
I got the method from Phutthathat Prateep Songtham, Chiang Rai Province, where the monk has installed various equipment and protection systems completely. For those who use high-voltage equipment without using electricity as a backup system, I recommend setting up and following the clip. It can prevent damage to the machine from power outages, power surges, and automatically switch the power. This is considered a complete installation. As for other features, you can add more depending on the modification. I set the clock to turn on the machine at 5:30 a.m. and set the time to turn off the machine at 7:00 p.m., which is the appropriate value. As for the Sinotimer value, set it as follows: P01 = 280v (factory value). It is recommended to set 250v. When the voltage exceeds 250v, the circuit will be cut off. P02 = 250v (factory value). It is recommended to set 230v after the overvoltage condition occurs. When the voltage returns to 230v for 10 seconds, the automatic circuit will be connected. P03 = 0.1s (factory value) P04 = 190v (factory value) P05 = 200v (factory value) It is recommended to set 200v. After a power outage occurs, when the voltage returns to 200v or within the specified range for 10 seconds (P09 = 10), the automatic circuit will be connected. P06 = 0.1s (factory value) It is recommended to set 0.1s P07 = 63a (factory value) It is recommended to set 10a P08 = 0.1s is the time that allows the load current to exceed 0.1 seconds. P09 = 60s (factory value) It is recommended to set 180 seconds. P10-13 It is recommended to set according to the factory value. https://www.lazada.co.th/products/kg3...